Anthem M1 State-of-the-Art Monaural Amplifier

Authorized Dealer
$4,799.00 CAD
+ taxes/fees
With 24 month financing

Call for availability

We now offer financing powered by

State-of-the-Art Monaural Amplifier

The highest sound quality at all volume levels, flat frequency response into any load, and stable into the most difficult loads. The Statement M1 is a state-of-the-art monaural amplifier delivering 1,000 watts into 8 ohms and 2,000 watts into 4 ohms or less with THD remaining under 0.1% from 20 Hz to 20 kHz. Designed and engineered in our advanced research center in Ottawa, Canada, the M1 is manufactured in our Toronto facility.

More than just a slim, technologically advanced monaural design, the M1 demonstrates that Class D architecture isn't fundamentally flawed, it simply hasn't been implemented well in the past, mainly because it required such a heavy commitment to R&D. We’re fortunate to have the in-house resources to create such a groundbreaking product and one listen will reveal the truly extraordinary nature of this amplifier.

  • Full resolution of all of the sonic subtleties and complexities in the input signal.
  • Accurate reproduction of the full dynamic range of the signal.
  • Output stage is never allowed to clip.
  • No compression as output increases.
  • Flat frequency response into any load, without having to resort to digital conversion or equalization to compensate.
  • Stable into all loads including open circuit and short circuit.
  • A low noise floor.
  • Exceptional efficiency with low heat output.
  • An amp so mechanically silent it will suit even the quietest listening room.
  • A design that allows multiple units to be stacked with no danger of overheating.
  • All of the above delivered at a price point that while not inexpensive, delivers virtually limitless dynamic fidelity.
Power Output continuous, 20 Hz to 20 kHz, <0.1% THD+N
8 1000 W
4 2000 W
3 2400 W
2 >2000 W depending on line voltage regulation
Frequency Response 20 Hz to 20 kHz
Open circuit+/- 0.1 dB
8 +/- 0.1 dB
4 +/- 0.1 dB
2 +/- 0.2 dB
Power Bandwidth
1000 W at 8 5 Hz to 45 kHz
THD+N at 1 kHz, 8 Ω
1 W0.01 %
10 W0.01 %
100 W<0.03 %
1000 W<0.06 %
Consumption standby mode, 120V mains<1 W
Consumption standby mode, 240V mains<2 W
Consumption operate mode, idle33 W
Consumption typical operation300 W
MD 19 kHz + 20 kHz, CCIF0.003%
S/N Ratio ref. 1000 W, IEC-A113 dB
Voltage Gain29 dB
Input Sensitivity 100 mV for 1 W output, 3.2 V for 1000 W output (8 )
Input Impedance10 k (RCA), 20 k (XLR)
Damping Factor800 to 1400 depending on frequency
XLR ConfigurationPin 1: Ground, Pin 2: Positive, Pin 3: Negative

Write a review